RF Multiplexer 8ch 1GHz News
RF Multiplexer 8ch 1GHz
2018.11 design update
migrate to kicad5 symbols and footprints. only minor changes to pcb-design. new PDF hardcopies of 2018.11 PCB, SCH, and BOM.
RF Multiplexer 8ch 1GHz
2018 September: Arduino MKR Zero controller and revised PCB
Revised PCB with 10-pin IDC/ribbon-cable for powersupplies and SPI-control. Control by Arduino MKR Zero with Ethernet shield. This arduino will be easier to integrate into a 1U enclosure, and removing the voltage-regulators for the mux-PCB simplifies the board.
RF Multiplexer 8ch 1GHz
2018 August: design revision
Revised design 2018.08 with a single 10-pin IDC connector for 5V and 3.3V supplies and SPI-communications. Also working on Arduino MKR ZERO controller.
RF Multiplexer 8ch 1GHz
2018 June: project created on ohwr
Following two prototype PCBs and some testing the project has been created on ohwr.org. Stay tuned for updates to the repository and documentation during the next few weeks.