30-07-2012: Microsemi First Articles validated ✓
For the validation, we have:
1) Run nanoFIP JTAG VERIFY cycles: one of the boards was acting as the
target TAP, and another was receiving JTAG frames corresponding to the
VERIFY_6A11.svf firmware.
The cycles were completed successfully! Also for confirmation a
different VERIFY firmware was sent and the JTAG cycles failed.
2) Kept the boards (each one with a different configuration in terms of
speed, var size, model/constructor etc) running in loopback mode for 3
days, with the heaters at 100% (temperature measured on surface by the
sensor: 40oC). No error occurred!
_* Note: The following NFTC boads are housing the First Article
units:
31.25 KHz: 201104-010
1.00 MHz: 201104-007, 201104-016, 201104-019
2.50 MHz: 201104-011_